Can you share the cost?I found a used one on E Bay at half the cost of new. The sale ad said make an offer so I did & got it for less & the seller was only a few hours away from us so we picked it up & saved on shipping.
The seller was asking $300.00 & in the ad it said buy now $300.00 or make offer. I offered him $250.00 & he accepted my offer & he was only a few hours drive from us so we saved the shipping cost & picked it up. I did see this trailer hitch bumper cover is for sale now on Ebay. It is located in Woodstock, Ga.
While I can appreciate it probably took you a lot to get to the point where you could be this relaxed about it, I really hope I can have your attitude should this happen to me
It's hard to tell from the photos, but there appears to be a significant gap between the skid plate and the OEM splash shield. If that's the case I would worry the skid plate would act as a scoop in loose dirt or sand. How much of a gap is there?
Today, Baby B got a Rough Country nudge bar and four more LED spots wired two center and two outer spots on separate switches. Tomorrow I’ll finish wiring up and test. Then I can clean up the wiring and tidy up the engine bay. Rock lights are in and the canopy was installed a few weeks ago. Tires upgraded to BFG KO2s. Last two bits are Ford installing the lift kit ( too much for me to do alone) and the rear facing light bar. Then I’m done…. For now?
Nice how hard was it to remove grill? Been wanting to install nudge bar,but afraid of breaking something. I did install my lift my self, but there’s really no plastic clips that can break. Thanks
It's flat to the splash shield but there is a small gap due to the bumper having a curve on the bottom and the skid plate having a sharp angle
