I technically made it here are the parts
RotopaX RX-TN Toyota and Nissan Truck Plate https://www.amazon.com/dp/B008S9QSJM/ref=cm_sw_r_apan_i_TPHW3FVYJY8M7WYQNCYV?_encoding=UTF8&psc=1
CAMVATE Extended Size C Clamp with 1/4" & 3/8" Mounting Points For Photographic Accessories...
Thanks!
Here is a close up of the bracket for the rotopax. It's been on the car for over 6 months and used many times. It's never moved even off-road and it's also easy to take off to use and fill. No concerns it's been great.
My leg was an after thought I added right before the first trip I used the kitchen and I haven't upgraded it since. It's just a tension rod with a cane foot attached that can be screwed on or removed when packing up, but it works! It stores with the stove.
I would suggest adding adjustable feet...
I used sand mode with low gear on. The trail is a nice mixture of scenic to moderate off-road with just a few harder parts. There's a more intense section with a very steep hill that is all large loose rocks, its worse going back up then down. The ranger will warn about this part but the bronco...
This is the new one. I have been talking with them for a couple months and they sent the first one to me. It completely different from the badlands model it's wider and covers way more under the vehicle
Rally innovations sent the prototype for non badlands models today. Here are photos of the install. The skid plate covers a large portion of the undercarage, Also it was powder coated with textured black
I had to trim like an inch off the front mud flap only. The differences I see between the bushwacker is the front in two pieces and the extra embossing around the bolts
-OMAC crossbars
-FSR adventure GS rooftop tent
-yescom awning
-rotopax gas can with universal plate
- don't remember which traction boards
-custom mount for traction board and gascan
Installed them over the weekend they look good and are decent quality ( surprisingly scratch resistant). The design is a little different from the bushwacker, they are actually more aggressive which I like. I would suggest screwing in the clips to attach or use good 3m tape for security but it's...
My most recent email is the prototype they made for me is being powder coated but delayed due to a large order but I should receive it next week. They have been really good at updating me