Let's Talk Rear Hatch Badges

[SilverVVolf]

If you have small kids, they may like this.

Ford Bronco Plush Toy

Good lookin' out, man! I might as well get 2 for both of em'. Lol

Sponsored

 

[ths0002]

Update: I bit the bullet and did it. Very pleased with how it turned out. I ended up purchasing an OEM Bronco emblem from Ford through the dealership.

 

[ZeroCool]

Update: I bit the bullet and did it. Very pleased with how it turned out. I ended up purchasing an OEM Bronco emblem from Ford through the dealership.

Damn i should habe got mine through the dealer.

 

[ZeroCool]

I’ll circle back to the thread and share my final product.

 

[ths0002]

Damn i should habe got mine through the dealer.

I’ll circle back to the thread and share my final product.

Yours looks awesome! That lettering is really cool! How did you do it?
My problem is that I get stuck on stuff matching and decided that I'd just stare at it if it didn't match the steering wheel haha

 

[ZeroCool]

Yours looks awesome! That lettering is really cool! How did you do it?
My problem is that I get stuck on stuff matching and decided that I'd just stare at it if it didn't match the steering wheel haha

My bronco horse looks smaller then yours, if mine comes off I’m heading to the dealership. Diamond vinyl decals did my overlay lettering. They did good.
https://diamondvinyldecals.com/

 

[NJBronco]

I think flossing out the "Sport" in the rear would look nice.

 

[nch5013]

Went the plast-dip route. LOVED the look - 1st go on the back. Did it 3 times on the front. Couldn't get it to stay adhered at the edges when I removed the excess. It would pull away and leave a bit of white. My OCD hated it. I like the vinyl less, but it is at least consistent in the edge. I may break down and hand paint them...oof. But I'm not to that point yet. Also have a chrome bronco to put opposite of the ford emblem I'm going to black and chrome. I havn't decided if I'm going to leave the bronco chrome or black it out as well...

 

[Glamdring70]

It would pull away and leave a bit of white.

JMO as a not well experienced Plasti-dipper, but I think you're over-masking. It breaks at the edges because of the heavy coat and extreme angle. You intentionally overspray it onto the body, and peel off the excess. Someone else, or a Yootoob video might offer more help.

 

[nch5013]

JMO as a not well experienced Plasti-dipper, but I think you're over-masking. It breaks at the edges because of the heavy coat and extreme angle. You intentionally overspray it onto the body, and peel off the excess. Someone else, or a Yootoob video might offer more help.

Thanks. I'll keep it in mind next go. Didn't have that issue with the back though and did the same thing.

 

[Tigger]

I’ll circle back to the thread and share my final product.

That’s cool! As a suggestion, I think I would do the blackout overlay on the Ford oval in a silver and black combo (or the carbon)

https://www.stickerfab.com/products/ford-bronco-oval-emblem-overlays-2021-bronco

 

[PugDad]

The side badges peel right off. I had to relocate them higher up when I put the side moldings on that overlapped the badge....... Very poor design intuitiveness.

You were able to reuse the side badges after removal?

Sponsored