Bronco script emblem installed

[Jrl]

New bronco script installed today. Looks pretty good.

Sponsored

 

[Jrl]

New bronco script installed today. Looks pretty good.

Thanks

 

[wbrainbow]

Did they fix them for left and right side or is one still backwards because they are the same for both sides.

 

[Jrl]

Did they fix them for left and right side or is one still backwards because they are the same for both sides.

Fixed

 

[Big Kahuna]

WANT!!!

 

[Tomp611]

Fixed

Could you let me know where you found your script emblems? Thanks!

 

[sinbuster007]

any of these with "sport" added??

 

[BodieBronco]

I'm about to have a day over 70 degrees with no rain, and I hope to apply my script.
Please help
Is there a template for the bronco sport? I found one for the bigger broncos.
What part of the fender area do I level from? I think I want to put it at the same height as the door handles.
Is there a way to do a wet application with these so I can slide it around to make sure it's perfect before committing?

 

[Jrl]

I'm about to have a day over 70 degrees with no rain, and I hope to apply my script.
Please help
Is there a template for the bronco sport? I found one for the bigger broncos.
What part of the fender area do I level from? I think I want to put it at the same height as the door handles.
Is there a way to do a wet application with these so I can slide it around to make sure it's perfect before committing?

Take a look , this might help .Buy 1 inch blue tape and match it to the hood joint and then 1 inch from the vent . That’s what I did if you like that look . Good luck .

 

[BodieBronco]

Take a look , this might help .

Yes. Exactly the positioning I'm aiming for. Trying to figure out how to measure and level and mark off so I get it right

 

[Jrl]

Yes. Exactly the positioning I'm aiming for. Trying to figure out how to measure and level and mark off so I get it right

Look at post I updated.

 

[Jrl]

Look at post I updated.

You can use your I phone to help level tape.

 

[Jrl]

I'm about to have a day over 70 degrees with no rain, and I hope to apply my script.
Please help
Is there a template for the bronco sport? I found one for the bigger broncos.
What part of the fender area do I level from? I think I want to put it at the same height as the door handles.
Is there a way to do a wet application with these so I can slide it around to make sure it's perfect before committing?

Please send pictures when done ,thank you .

 

[Escape2Bronco]

Yes. Exactly the positioning I'm aiming for. Trying to figure out how to measure and level and mark off so I get it right

You might be able to temporarily hold it in place using some high strength magnets just to get an idea. Then place your tape below and mark the start and end spots. I’m assuming the badges are plastic and not heavy.

 

[Cactusjk]

If someone mounts one using the tape please take pictures of the tape position and alignment.

Sponsored