Ambient Lighting install / enabling - DIY project

[pantera155]

I was not able to find splice S207 in PTS, but the connector that @DonImbimbo mentioned C2280B does mention ambient lighting in some of the pins. It mentions postive and negative for the ambient light sensor, but no mention of the LIN: See attached; it is located here:

Thank you so much, rugedraw.

What you said has confused me about the correct circuit... I connected pin 31 of the C2280D and pin 4 of the C2280F. But pin 4 has no voltage.

So we're off to a bad start! I'm wondering if it has a fuse or if the correct circuit is the one you described.

Sponsored

 

[rugedraw]

Thank you so much, rugedraw.

What you said has confused me about the correct circuit... I connected pin 31 of the C2280D and pin 4 of the C2280F. But pin 4 has no voltage.

So we're off to a bad start! I'm wondering if it has a fuse or if the correct circuit is the one you described.

I got that from Ford's workshop manual for a 2025 BS. Unless the info is wrong which would not surprise me.

 

[pantera155]

I got that from Ford's workshop manual for a 2025 BS. Unless the info is wrong which would not surprise me.

Very thanks!

It's strange that Ford is changing the wiring for the 2025 version!
Could you upload the information for the C2280F connector?
I need to find the LIN cable

Sponsored