- Thread starter
- #1
I like the Ford rubberized mats. They honestly look nice and are effective OUTSIDE of the fact that the drivers side doesn't extend up under the gas pedal area.
It makes no sense why they would design it that way....but regardless they came with the vehicle and they do look nice...
I was wondering if any one on here would be able to 3D print an extension piece on the top side of the mat that would cover under the gas pedal and maybe even extend that whole side up some ?? then it could be riveted onto the existing mat
It makes no sense why they would design it that way....but regardless they came with the vehicle and they do look nice...
I was wondering if any one on here would be able to 3D print an extension piece on the top side of the mat that would cover under the gas pedal and maybe even extend that whole side up some ?? then it could be riveted onto the existing mat
Sponsored