What did you do TO your Bronco Sport today?

[GoHack]

Got her dirty, what else?

Took my BL up into the Sierra's today, into the Inyo National Forest near Bishop, CA, trying to break her in offroad.
No issues to report.

On the way back home, I went through Dead Valley from the Nevada entrance.
The temperature down in the lower valley was 116 F. ?
The hottest I've ever encountered there was 118 F.
They had posted advisories stating not to use your A/C, for fear of overheating your car/truck.

Boy I'm glad I went w/the Full Synthetic engine oil. ?

Sponsored

 

[Mrmike]

New rear cargo cover!

Saw this here on the Forum. Easy install, good looks and fit. Just nervous about the two-sided tape tape holding the rear brackets.

 

[jkernitzki]

New rear cargo cover!

Saw this here on the Forum. Easy install, good looks and fit. Just nervous about the two-sided tape tape holding the rear brackets.

I think you need a new potato.

 

[rorlow]

Added Erkul Skybar V1 crossbars after going thru a nightmare scenario with an eBay crossbar seller.

**Edit: bottom pic- Finally got around to getting tint done, really happy with the installation and the tint install techs.

 

[davidg4781]

Got her dirty, what else?

Took my BL up into the Sierra's today, into the Inyo National Forest near Bishop, CA, trying to break her in offroad.
No issues to report.

On the way back home, I went through Dead Valley from the Nevada entrance.
The temperature down in the lower valley was 116 F. ?
The hottest I've ever encountered there was 118 F.
They had posted advisories stating not to use your A/C, for fear of overheating your car/truck.

Boy I'm glad I went w/the Full Synthetic engine oil. ?

Looks amazing!

Did you use your A/C?

 

[CancunBadlands]

I think you need a new potato.

Zoom in! ?

 

[Putter Boy]

One of the things that bugged me a bit was that Ford chose to equip my Badlands with LED lighting everywhere BUT the taillight turn signals, brake lights, and backup lights. So today I took care of that and changed out the bulbs with LEDs:

For those are interested, the LED Bulb types you'll need are as follows:

Turn - 921 Amber
Brake - 3157 Red
Backup - 7443 White

Installation was a snap. Changing out the bulbs is well documented in the owner's manual but all you need is a 10mm nut driver or socket wrench. Always be careful when working the housing tabs off of the studs (you REALLY don't want to break one of those) but the whole change-out took me less than 15 minutes.

I used bulbs from Diode Dynamics (www.diodedynamics.com) as they are an American based company and the quality of their products as well as customer support are outstanding (3 year warranty, but I've had them in my Fiesta ST for nearly 6 years now without a failure). But for those on a budget there are admittedly less expensive options out there.

While it's hard to see in the daylight pic, the backup LEDs are probably the biggest improvement in the cars I've put them in, with a noticeably brighter and whiter light than stock.

I found these turn signals in amber that work great no issues at all on both 2025 Bronco Sports Outer Banks and Big B. from amazon.

921 Amber replacement turn signal bulbs no fast flash

 

[GoHack]

Looks amazing!

Did you use your A/C?

Outside of Death Valley, yes.

Inside the park, I kept the settings down to the very minimum.

 

[rorlow]

Tuffskin flat black Bronco overlays installed today.

 

[Chiefthepup]

Tuffskin flat black Bronco overlays installed today.

Just a warning I feel obligated to share due to my own experience,
Careful with those liftgate letters. Was drying with a towel after a wash and the towel snagged the “T” and snapped the top right of it clean off lol

 

[rorlow]

Just a warning I feel obligated to share due to my own experience,
Careful with those liftgate letters. Was drying with a towel after a wash and the towel snagged the “T” and snapped the top right of it clean off lol

I removed all the tailgate lettering, not a fan of the white tailgate lettering, but thank you for the warning!

 

[Putter Boy]

I removed all the tailgate lettering, not a fan of the white tailgate lettering, but thank you for the warning!

Did you use a heat gun or dental floss?

 

[rorlow]

Did you use a heat gun or dental floss?

Used a heat gun on low, than lots of GooBgone to remove 3m residue. Followed up with clean and rewaxing ?

 

[Putter Boy]

I removed all the tailgate lettering, not a fan of the white tailgate lettering, but thank you for the warning!

What exhaust is that you installed. ? Thank you.

 

[Putter Boy]

Looks amazing!

Did you use your A/C?

Where did you get your stripes from?

Sponsored