What did you do TO your Bronco Sport today?

[bluebabybronc]

Not today but I put a roof rack on when it was -20 out and drilled through the front crossbar to mount recovery boards the other week. They’re just so damn big for the trunk. Put those splash guards on myself, too. Will install a frost plug engine heater and FRL 1.75” lift… waiting for it to ship and me to not have COVID. I might even try to build a custom strut tower brace.

Sponsored

 

[vxarctic]

Got my 10k maintenance milestone finished and had them install a transmission oil cooler to finally complete my tow kit. Also had the lower b pillar on the driver side replaced. The clips broke either from a when the trailer hitch power cable was ran or from me jumping into the thing. Feels like new!

 

[rocks]

Got my 10k maintenance milestone finished and had them install a transmission oil cooler to finally complete my tow kit. Also had the lower b pillar on the driver side replaced. The clips broke either from a when the trailer hitch power cable was ran or from me jumping into the thing. Feels like new!

Nice!
What did Ford service charge for the trans oil cooler and install?

 

[vxarctic]

Nice!
What did Ford service charge for the trans oil cooler and install?

That was the not so nice part, initially it was a couple hundred with the tubes etc. But mid install they approached saying that they quoted me for a different install and sprung $800 on me to do it/finish.

 

[bluebabybronc]

That was the not so nice part, initially it was a couple hundred with the tubes etc. But mid install they approached saying that they quoted me for a different install and sprung $800 on me to do it/finish.

I would be complaining about this one.

 

[Rhel]

Did drive to the peer to see some ?

 

[Mwittke5857]

Installed a Pedal Commander... WHAT a difference!

 

[Nam3]

Installed a Pedal Commander... WHAT a difference!

Pedal Commander is life. When I turn it off it feels like I have to put my foot all the way to the floor just to maintain speed.

 

[Mighty3]

Had some time today and rain stopped. Had my stock Big Bend since September but was rounding up all those parts. Keep them all in a pile. Wife thought I'm nuts. Added hood insulator, hood left and right seals, under dash pasenger panel, the elusive engine cover (sorry), tow eye, bought the Ford big soft sided cargo holder, grabbed a HBF tools folding shovel, HBF lithium jumpstarter (always should have had one) and Xbull 'gen3' boards from that eplace just in case of nasty snow. Still thinking about those fender apron insulators! Received a Bronco sweatshirt as a gift from my son. Let it snow!

 

[rocks]

After going back and forth on deciding to get the cover, I caved and am happy about it. I got it with 10% off leaving it in the cart and getting an email with the discount.
The cover is a quality pretty heavy piece. Maybe a bit overpriced but solid as is the hardware. Plenty of air venting and it sits above the engine and not as confining as the OEM cover if one is worried about heat build up. It should keep the top of the engine and the components a bit cleaner. All in all, a nice mod.
The reps are great with any questions you have on the cover. The cover is also packed very well.

 

[CrazyKZ]

Installed a Pedal Commander... WHAT a difference!

Where is everyone mounting their units?
The app looks like it might need help and I don't want the unit to be sticking in front of my face, but accessible. Any recommendations for the BS? Planning on making the purchase this week since it's on sale. I already run my BadLands in Sport mode 100% of the time. Do I need to use the Sport mode on the BS AND the PC? The Sport mode does change the shift points (which I like) so it sounds like I need to use both.

 

[supaDean]

Had some time today and rain stopped. Had my stock Big Bend since September but was rounding up all those parts. Keep them all in a pile. Wife thought I'm nuts. Added hood insulator, hood left and right seals, under dash pasenger panel, the elusive engine cover (sorry), tow eye, bought the Ford big soft sided cargo holder, grabbed a HBF tools folding shovel, HBF lithium jumpstarter (always should have had one) and Xbull 'gen3' boards from that eplace just in case of nasty snow. Still thinking about those fender apron insulators! Received a Bronco sweatshirt as a gift from my son. Let it snow!

Hi. Can you provide a link for the engine cover? Thx.

 

[Deleted member 6350]

After going back and forth on deciding to get the cover, I caved and am happy about it. I got it with 10% off leaving it in the cart and getting an email with the discount.
The cover is a quality pretty heavy piece. Maybe a bit overpriced but solid as is the hardware. Plenty of air venting and it sits above the engine and not as confining as the OEM cover if one is worried about heat build up. It should keep the top of the engine and the components a bit cleaner. All in all, a nice mod.
The reps are great with any questions you have on the cover. The cover is also packed very well.

Looking Mighty Fine There Rocks

 

[rocks]

Looking Mighty Fine There Rocks

Thanks, Steve. Also thanks for the info you gave me on the cover.

 

[mrs mighty]

Levittown Ford parts has the body side molding for $264.85

https://www.levittownfordparts.com/part-ymm/2021-ford-bronco-sport-molding.html

I just ordered some via my dealer Saturday. I had Ford Pass Rewards of $200, so I used them ??. I’ll have them installed I’m thinking this week when they come in. I can’t wait ?

Sponsored