Additional outer hood graphics (from Underground Graphics)

[EARLSAYS]

About a month or so ago, I installed the three piece hood graphics to reduce glare on my Bronco. I was VERY happy immediately, no more glare, and they look. Ice too! well, I found thst the outer sections - the flat areas on the hood still produce glare. So, I had UG make me some matching pieces.

Sponsored

 

[EARLSAYS]

Here’s some better daytime photos

 

[rocks]

Not a fan but you like it and that's all that matters.

 

[Bronco 92154]

 

[RushMan]

About a month or so ago, I installed the three piece hood graphics to reduce glare on my Bronco. I was VERY happy immediately, no more glare, and they look. Ice too! well, I found thst the outer sections - the flat areas on the hood still produce glare. So, I had UG make me some matching pieces.

I want those in flat black. I thought it was odd that UG sold only the 3 piece package since thry can't do a one piece wrap, due to the hood bulges.

 

[EARLSAYS]

they said that initially they attempted a single piece, and there were too many contours to make it easy to work with

 

[RushMan]

they said that initially they attempted a single piece, and there were too many contours to make it easy to work with

Yeah, I saw that post. I ordered the side pieces from an Etsy vendor and the 3 piece set from UG. My car should arrive in about 2-3 weeks.
Originally, I was going to spray paint most of the hood with Plasti-Dip following the contours of the bulges but leaving the sides and front edge of the hood in factory paint.
Either the matte black vinyl or the matte black Plasti-Dip should look OK on my Shadow Black BS BL, I hope.
I'll install an air deflector on the hood covering the raw paint area. While waiting for my ordered car, I've bought essentially all of the personalization items that I want.
It will be like a late Christmas for me, opening up all the unmarked boxes of items for my new car.

 

[NMhunter]

I do hate the glare. How difficult was the installation?

 

[EARLSAYS]

I do hate the glare. How difficult was the installation?

not difficult at all, line them up, masking tape, remove half the backing, squeegee it down, remove the rest of the backing, squeegee the rest, eliminate the air from any bubbles, done.

 

[Luis@UG]

Installation video

Sponsored