Picked up vehicle next day. Battery voltage issue was a service advisor mis-statement. All systems working and data back at pre-update values. Completed survey today and was brutally honest.
Sponsored
Recall: Instrument Cluster Panel Display Failure (NHTSA Recall 25V788) -- 2025-2026 Bronco Sport
BACKGROUND
After the IPC firmware update, I noticed two things.
1. The My View settings get reset back to factory defaults 1 of 10 vehicle trips. (Previously mentioned)
2. My drivers side window does not stay rolled up all the way. Example, I went to the touchless car wash recently and of course I check all the windows are rolled up. When use the window switch to roll up the windows, it rolls up approximately 1/4 inch, then immediately rolls down 1/4 inch when I release the windows switch. The window did not leak. All the other windows stay all the way up.
QUESTIONS
1. Is this a calibration issue and how do I correct it myself?
2. Or since this is the most used window, there is a mechanical defect or limit switch problem that I need to take to the deal to fix?
After the IPC firmware update, I noticed two things.
1. The My View settings get reset back to factory defaults 1 of 10 vehicle trips. (Previously mentioned)
2. My drivers side window does not stay rolled up all the way. Example, I went to the touchless car wash recently and of course I check all the windows are rolled up. When use the window switch to roll up the windows, it rolls up approximately 1/4 inch, then immediately rolls down 1/4 inch when I release the windows switch. The window did not leak. All the other windows stay all the way up.
QUESTIONS
1. Is this a calibration issue and how do I correct it myself?
2. Or since this is the most used window, there is a mechanical defect or limit switch problem that I need to take to the deal to fix?
Owners manual has the window reset procedure, on mine it is:
Resetting One-Touch Up
Start the engine.
1. Lift and hold the window switch until you fully close the door window. Continue to hold the switch for a few seconds after you close the window.
2. Release the window switch.
3. Press and hold the window switch until you fully open the window.
4. Release the window switch.
5. Lift and hold the window switch until you fully close the window.
6. Test for correct window operation by carrying out the one-touch down and one-touch up features.
IPC resetting to MyView is a known issue affecting all Ford vehicles.
To reprogram the window, turn the truck fully on engine running. Lower window all the way and hold it for 5 seconds after it is all the way down. Then raise the window and hold for 5 seconds once it goes all the way up.