Probably this one? Bronco Sport Hatch MOLLE Panel
I'm not sure what's behind the plastic trim panel, but it may be possible to use some rivet nuts and spacers to fortify the mounting points.
No idea on the part numbers, but I'd swap mine for yours....lol
Offer goes to anybody interested in trading. I'm in SoCal a hop skip and a jump from Lake Perris.
After measuring ten times, test fitting, and some hope and prayers, I finally finished trimming the monster-sized Rhino Rack platform down to the size I wanted. I had to do around a dozen cuts, and drill around the same amount of new holes....lol
Once the width was trimmed, I had to shift the...
I'm not sure it would be legal to transport pets on my hitch mount cargo carrier, so I'm sticking with the no pets allowed rule for now! Once I get my roof rack installed, I'll check into the legalities of both....lol
I voted for the pet hair, paw prints only, because I've seen them in my wife's and daughters' vehicles.
My Bronco Sport is mostly a driveway King, and the no pets allowed rule is strictly enforced.
Something similar to the rear cargo management system, but higher up like the retractable cargo covers.. I have a few ideas, but I'd need to see what's left over to play around with.
Gearing up for future adventures! Impulse buy. The Pioneer Platform will be trimmed to fit once I figure out the exact measurements I want. Depending on the size I land on there may be enought leftovers to make a rear shelf?