Recent content by JcrOffroad

Sorry for the delay! Really busy week this week. Wanted to make sure we had the install video up at release! But the engine covers are Available! https://www.jcroffroad.com/product/BSGNC.html

Working on it!

All installation hardware is included. It will be powder coated black.

We are expecting these to be for sale Monday or Tuesday!

That is from us! We have a 1.5l too!

We are working with lift struts depot to get a part number for a pair of 194lb struts with the correct angle brackets on the website to make ordering easier. We will post a link when it's available, but they said the part number will be PM4310. We will add the info to the product page as well...

We do not. Have not had access to one for R&D.

I have not seen that.

There are no modifications required for the badlands. unfortunately we do not have an install tech at this time.

As promised, here is the front lower bumper bash plate: https://www.jcroffroad.com/product/BSSD-BSH-1G.html

You would remove it.

It comes with both. Our drive side skid plate is an upgrade over the badlands offering.

Wrapping up the front lower bumper protection plate:

The skids do not interact with each other, so you can mix our skids with factory skids. Our sliders require our evap/floor skids. It’s a structural requirement. The BS is a unibody, so you MUST support the sliders correctly or you will do substantial damage to the BS.

I’m not sure if I would swap BL front skid for ours. Really depends on your budget. Functionality as a skid, will have similar results. The ability to change oil without and a cleaner design are the two main differences.