Rough Country Bull Bar Advice Needed for License Plate

[paddywampus1]

Pretty much the title. I installed the bull bar with the 4 round lights as shown below. I live in a state where a front license plate is required, any come up with a good way to get the license plate up?

Thanks in advance!

Sponsored

 

[Major Kong]

Pretty much the title. I installed the bull bar with the 4 round lights as shown below. I live in a state where a front license plate is required, any come up with a good way to get the license plate up?

Thanks in advance!

Hope this makes sense
Continue with the Bull Bar Theme
PCV sized to bar diameter
PCV painted black to match bar
red line indicates cut line through 90 degree bend
vertical slot on inside of vertical PCV tube section for holding plate
attach (cut) 90 bends, plate and assembled pcs to lower bar of Bull Bar

possibly pull it off on the cheap and maybe not looking half bad either

*Kong Edit
Replace drawing top 90 bend with "Tee" fitting
90 bend would have left a segment of PCV in the way of a nested fit

 

[Mark S.]

Pretty much the title. I installed the bull bar with the 4 round lights as shown below. I live in a state where a front license plate is required, any come up with a good way to get the license plate up?

Cushioned loop clamps. Google search to see what I mean.

Sponsored