Search results

Thanks. How do you like the 5star tune? Was it off shelf plug and play ? I decided to go with Livernois. Still waiting on the tune.

Not bright orange all over like mine ?

The heat shield has very sharp edges I noticed that as well. It's supposed to be stiffer but the biggest change is the ability to change the end link position on the steeda bar. I'm guessing it increases stiffness due to increased resistance of the bar thus reducing twisting on the bar itself...

Appreciate the clarification. For comparison, here is 70k mile tahoe and 1977 corvette.

Not normal with any vehicle. There are bare metal parts on the vehicle that don't look like this. There is a bare metal part right next to it you can see in the photo. Brake shields are also bare metal and they don't have the same level of surface rust. My 1977 corvette is 47 years old and the...

Got the rear sway bar installed. Was a PITA but got it done.

Finally got a chance to install the rear sway bar. In theory it's a super easy install. In reality, getting the oem bar out and the steeda bar in is a real PITA; unless you disconnect the drive shaft. I decided to leave the drive shaft alone. Several hours later, after lots of hand nicks, some...

Thanks. Seems weird, almost like they didn't coat the part. I've seen photos of other BS that have been on the road longer and the knuckle seems to be coated.

What's up with my steering knuckles being completely covered in surface rust? I only have 1,036 miles on my BB.

How much time did you spend on the sway bad install and which install position did you select?

It has improved the ride. Smoothed it out a bit but I'm still not fully satisfied. I'll be looking for upgraded shocks and struts. I also have the Steeda rear sway bar to install soon.

Added a Steeda strut tower bar. Super easy install. 15 minutes tops.

Added some interior bling.

That's what I plan to do :fingerscrossed: except for the drop. Hoping to improve the clunky ride a bit with the tower brace and rear sway bar.

Which mounting position did you install? The least stiff, middle, or stiffest position?

Added LuminX tint to the fogs

Amazon

Made the weird side trim functional

Installed hood lift supports. No more manual hood prop

Which bilsteins do you plan on using?