Search results

if it were an actual race i doubt the sport would come out ahead even against an ecoboost mustang. might be a close one though.

^ this Not really understanding what you're going for here.

I just want to see someone use forscan to enable lincoln experience on the power folding mirrors. I briefly looked into getting the mirrors from Brazil market that have the signal markers in them, but that was a bit hard to find a source. This would hopefully be a more attainable retrofit...

Buller point look like a cheap afterthought to me. Tackform is sleeker and becomes part of the dash

They're factory tow hooks that are equipped on the badlands trim

the factory mats design will match the design of the cup holder and pocket rubber inserts, and rear cargo floor. its leaking. theres a thread about replacing the check valve good luck getting someone to part with one of those. they seem to be a rare configuration. tackmount.com im not a...

pretty sure one of the over a dozen threads about moaning brakes already has a poll. do some reading.

Took apart the driver door panel just enough to get a peek to see if the harness for illuminated keyless entry pad is present. One thing our big bend had that this badlands doesn't, (also the rear folding headrests) Had to check for myself because ford's website says not available for badlands...

I had bought some Bosch wipers for my sister in laws car a 2021 jetta and the instructions were terrible. And about 3 of the ends you clip on look very similar. After struggling to make the correct one fit for a minute, then trying the wrong one, went back to the first and it popped right in...

Not well enough lol

Damn

I've had those tail lights out a few times. Protected by what? Did they change something for 2025? I've still seen it get dirty behind that lamp. Water can easily get behind there. I'm not a fan of poking holes in the body. I would just be worried about future corrosion. Your wire taps are okay...

:crying: the mounting holes. Did you use some silicone or something on the holes?

No changed the actual lenses from the baja "amber" to factory amber. The ditch lights still have the baja "amber" for lens color reference Usually some heat from even a hair dryer is enough to strech vinyl. But the lamin-x should be cut to fit. You could do a wet set with some water in a spray...

anything off this album

lots of options for fiesta and focus accelerator pedal only, spacer. not sure if mounting position is the same or not. basically raises accelerator pedal about an inch. some are machined aluminum, or 3D printed.

did you have the front windows done also? i wanted to do 30%on all and 65% on the windscreen. but wife wanted to go a little lighter in the front.

:clap: just asking a question

did you fix it yet?

Still working on perfecting this one. Still need to work on a name.