3D printed phone mount I made

[Idontknow]

I feel like it should hold up well if you’re using the magnetic mount option. You aren’t putting any stress trying to slide it into a holder. The proclip ones aren’t metal they are plastic but yes do attach exactly the same way.

Sponsored

 

[Mlarv]

Howdy the PLA will not hold up in the long run. ABS would be best but PTEG will work. The heat and cold temps will break down the PLA.

 

[xm41907]

I found this on thingiverse and printed it. I was able to take the magnetic mount from my old car and install it on the ball. Fits perfect and cost me about 50 cents to print (100% infill).

Sponsored