Search results

Got passenger side top roof section self vinyl wrapped today. Definitely don't need to remove racks for those. 12" x 8' piece of 3m 2080 black gloss was perfect. Tucked top under roof rack rubber seal.

After driving my new BB for a couple days, I noticed the steering was really loose and felt a little scary on highway turns at 60-70 mph. The ride was also hard and felt like wheels were a bit unstable on sharp side-weight turns (like off ramps). As most point out already the tire pressure was...

Picked up (Whoa!) Nelly today. A lot of searching and effort to get it but worth it! Let the fun/projects begin. Original silver BB (w/ BB pkg): Planned mods: (Black roof, black wheel edges, gray pinstripe to match gray BB grill, gray rear letter, eventually 235x60r18 HT tires)... Update...

FYI, I got my BB today. I don't think you need to remove the roof racks to vinyl roof. The roof rack is in a gully and has liftable rubber seal on both sides. This means that the 2 narrow side pieces and large center piece of vinyl can be tucked under the seal and over the gully edge. If you...

No, was looking at your diagram but now see it highlighted only the front screw on each rail. Based on maxwellion's post (thanks!) looks like have to undo rails from inside. Bummer, not brave enough to ruin something yet. Get my BB this Tues. Is there enough area to get vinyl on thin roof sides...

I'm planning on doing this too. Did you figure it out? Just the two HN1 screws holding it down?