If you look closer at my pic it is a rough country push bar but I modified the light setup and put two small bars with space for navigations (front center of grill) where the long light bar that I bought with the bar was supposed to go . Then I put the long light bar under the push bar. Running...
They are actually black chrome (slightly) you can tell in person. I had bought some fully black(plastic) ones but when I taped both sets of them to the car, those looked the best so I put the black ones on my toolbox .
Rough country nudge bar. Taking the front of the Bronco Sport off to install the brackets for it made me nervous but with some patience , cardboard and a shipping blanket I was able to do it by myself without damage . (Would recommend an adult helper) Also for any added lights, run wiring prior...
I put two short bars leaving a space between for front 360+ to work properly and mounted a long bar underneath by drilling more holes . Customizing should always be a personal touch . I like how mine turned out but if you like round , who cares what anyone else thinks :) also the ditch lights I...
I have this Milwaukee air pump and love it (only had it a year so far ). Uses M12 battery. Filled all 4 tires several times over the past year and still on full charge. I take it on EVERY trip along with my travel pack ( road flares, tire plug kit, battery jump start and a 6 ton 12v hydraulic...
Ran the wires through the holes I put in the front fascia for the push bar mounts and from there to a relay near battery and from there to the switches ( running wires thru grommet for door wiring inside open door ) and to the battery for power) I put 2 switches in a double switch box in my...
Yes the lights are the only thing blocking the sensors whe I bought 2 - 12” LED light bars from rough country that combo didn’t block the sensors like the single bar did . It did require me to buy longer brackets but turned out awesome when done .
I don’t think this could be used for pushing or pulling really . The 4 bolts(2 per side) in slotted holes are strong enough to keep it from moving around much, but it’s more for looks than for utility. That’s of course my opinion from personal observation. Hope they answers your question .
The brackets I received from rough country were useless to mount the LED light bar without hitting the grill and it also blocked the lane sensor /adaptive cruise sensor area (center square area of grill ) so decided to drill holes under the lower bar and mount the light bar there . I had to add...
So I added a push bar on the front and added two sets of led lights one long and two short . Had to modify push bar to fit and still be able to use my adaptive cruise control and lane assist etc . Turned out good I think but was some work for sure . Sorry car is dirty on pics but it was down...
I added hood vinyl and on door bottoms. I also plasti-dipped bronco on front and rear since these pics . Also added bronco horse on drivers door and back hatch in black chrome