- First Name
- Danny
- Joined
- Oct 6, 2021
- Threads
- 3
- Messages
- 10
- Reaction score
- 14
- Location
- Nampa Idaho
- Vehicle(s)
- 2021 Ford Bronco Sport
- Thread starter
- #1
So I saw a lot of questions regarding where to run the wiring harness for the Rough Country roof light bar. This is what I came up with after much consideration, first and foremost I'm not drilling holes in the roof of my brand new truck so being a retired race car fabricator this is what I came up with, once you mount the light bar bring the harness 180 degrees toward the front of the truck, then you can tuck the harness in right next to the A-Pillar trim piece and run it all the way down to the engine bay. Once in the engine bay there's an air seal where it seals off the cowl from air and weather, I simply cut the air seal down the center and tucked the harness inside all the way over to the drivers side then silicone sealed the weather seal and it drops the entire wiring harness right next to the battery, here's a picture of the finished install, if you have any questions please feel free to hit me up.
Sponsored