- Thread starter
- #1
AutoStopEliminator.com
Installed the Auto Stop Eliminator today and right now I'm happy with it. Started Bronco Sport up after install and automatically shut off Start/Stop function. That's all I was wanting.
Install took about 15 minutes but I struggled a little getting under the dash. Hopefully these pictures will help.
1. Auto/Stop Eliminator install instructions
2. 2021 Bronco Sport Kit
3. Driver's side lower left of steering column for the data port location.
4. Connection of how data plug is attached looking up at. Simply push up on clip to release and pull plug out toward the front of vehicle.
5. Data cable unplugged from data port and ready to install Auto Stop Eliminator.
6. Connect to data cable and be sure when connecting back to data port the securing clip is facing downwards as seen in picture 4. Once connections are made secure as needed with ty-wraps.
This is just to help...."I have no professional training ". Haha! Good luck.
If I would have to take it in for service it would be very simple to unplug again and remove. I'm personally not worried about it but I realize everyone is different.
Working just how I wanted it to, when I start the Bronco up screen pops up and tells me my auto start has been deactivated and the OFF light illuminates "on" the push button. The pushbutton does still work. If for some reason I want to turn it on I just push the button and the system will turn on or off.
Installed the Auto Stop Eliminator today and right now I'm happy with it. Started Bronco Sport up after install and automatically shut off Start/Stop function. That's all I was wanting.
Install took about 15 minutes but I struggled a little getting under the dash. Hopefully these pictures will help.
1. Auto/Stop Eliminator install instructions
2. 2021 Bronco Sport Kit
3. Driver's side lower left of steering column for the data port location.
4. Connection of how data plug is attached looking up at. Simply push up on clip to release and pull plug out toward the front of vehicle.
5. Data cable unplugged from data port and ready to install Auto Stop Eliminator.
6. Connect to data cable and be sure when connecting back to data port the securing clip is facing downwards as seen in picture 4. Once connections are made secure as needed with ty-wraps.
This is just to help...."I have no professional training ". Haha! Good luck.
If I would have to take it in for service it would be very simple to unplug again and remove. I'm personally not worried about it but I realize everyone is different.
Working just how I wanted it to, when I start the Bronco up screen pops up and tells me my auto start has been deactivated and the OFF light illuminates "on" the push button. The pushbutton does still work. If for some reason I want to turn it on I just push the button and the system will turn on or off.
Sponsored